PowerCOM Forum

With an earlier version I managed to Hide the polling results of a slide during the presentation and then, if the audience wanted to see the reults for that particular slide, press "D" on the keyboard.

I just downloaded V2.22 and this feature does not appear to be working anymore? Now if I hide a slide it is and stays hidden. The "D" is greyed out if I right click on the little poller status box.

Am I missing something? This is happening on 2 diffent computers

PowerCom new version will not allow you to display the result if you set hide the result during Poller design. If you like to decide at slide show time to show or not show result, please do not set hide the result during Poller design. During slide show, press next page when polling stop to skip showing the result. You always can go back to the slide and display D to show result.

When you absolutely sure you are not going to show the result, then use hide result.

This is the best way to prevent accidently show result.

 

Thanks for the reply. I really liked the previous versions feature to Hide all the slides, but then to change your mind with some slides and show it.

The thinking behind it is the following case:
You do a group voting session and decide beforehand that you need to get the unbiased input from the group. So you would not like to show them the slides. During the meeting, perhaps the personm from top management insists that you should show a particular result. Previously you could keep him happy by clicking on "D" and then just continue as before...